![Fantum Karpets](/img/default-banner.jpg)
- Видео 78
- Просмотров 1 019 862
Fantum Karpets
Канада
Добавлен 29 сен 2011
Flooring Installation. Manitoba, Canada Since 1998
"And whatsoever ye do, do it heartily, as to the Lord, and not unto men;" Colossians 3:23 KJV
"And whatsoever ye do, do it heartily, as to the Lord, and not unto men;" Colossians 3:23 KJV
Видео
Time-lapse of a Vinyl floor install
Просмотров 2,9 тыс.4 года назад
Time-lapse of a Vinyl floor install
Headlight restoration on my 2015 Toyota Tundra with mothers plastic polish
Просмотров 3,3 тыс.4 года назад
Headlight restoration on my 2015 Toyota Tundra with mothers plastic polish
Installing 3000 sf of carpet tile on a concrete floor in a church basement.
Просмотров 9 тыс.4 года назад
Installing 3000 sf of carpet tile on a concrete floor in a church basement.
Installing an American Standard Ravenna 3 Toilet.
Просмотров 4,9 тыс.4 года назад
Installing an American Standard Ravenna 3 Toilet.
Felt backed Carpet Install instructions
Просмотров 31 тыс.5 лет назад
Felt backed Carpet Install instructions
Time Lapse of a basement carpet redo
Просмотров 1,5 тыс.5 лет назад
Time Lapse of a basement carpet redo
A Time-lapse of a Bathroom Commercial Vinyl Install
Просмотров 5966 лет назад
A Time-lapse of a Bathroom Commercial Vinyl Install
Installing X-Board as floor protection
Просмотров 18 тыс.6 лет назад
Installing X-Board as floor protection
Removing old Carpet an Installing New Lux Click Plank
Просмотров 1516 лет назад
Removing old Carpet an Installing New Lux Click Plank
Installing Carpet on a Concrete Floor
Просмотров 252 тыс.6 лет назад
Installing Carpet on a Concrete Floor
Installing underlayment and vinyl in a new house/
Просмотров 6516 лет назад
Installing underlayment and vinyl in a new house/
Installing 5300 Sf of Vinyl Composite Tile in 3 Days.
Просмотров 3446 лет назад
Installing 5300 Sf of Vinyl Composite Tile in 3 Days.
Installing Indoor Outdoor Carpet on Garage Steps.
Просмотров 42 тыс.6 лет назад
Installing Indoor Outdoor Carpet on Garage Steps.
Installing Tack Strip and Pad on a Painted Concrete Floor
Просмотров 9 тыс.6 лет назад
Installing Tack Strip and Pad on a Painted Concrete Floor
what did you use on the seams
No railing on a raised deck?
It came in later
Hey brother great video what kind of vinyl is that exterior? Never seen it before
How is this deck holding up today.?
Do you need to put a UV protected so the sun doesn’t fade it out… I’m looking to do this on a concrete patio
There is no need for any additional UV protection, it can go on to a concrete pad but it would require a little bit more additional prep
Q calidad. Me encanta. Fue mi primer trabajo q ise cuando empese😔
Awesome video,I really admired it
This is awesome and we will absolutely spend money with you after watching this video :)
Love it.
That vinyl came out pretty easy. What adhesive did you use?
Nice work. How do you do inner corners?
What glue do you use?
It would depend on which carpet tile we use but on this job I do believe we used Eco 810
@@mrfantum1 yeah we have existing carpet tile that has a glue that you can pull the old tile up and put a new tile down but sometimes some of that adhesive comes off. Tried researching this specific type of glue as I don't have the original bucket and nothing states about being able to pull a tile off and put another one back down. I appreciate it.
Often I determine whether I want a releaseable adhesive or not releasable based on the type of traffic that you get on it. And I have a traffic area you may not want a releaseable adhesive. Especially if there is sliding chairs or any type of furniture or anything that could catch the edge of the carpet tile.
@@mrfantum1 Its for an office that one person sits in....not a ton of traffic
Done right. Power stretched. Just watched 6 dudes on you tube giving tutorials on knee kicking in basements. Everything has to be power stretched. You can't give a knee kicker tutorial on you tube and have it work. Knee kicking takes a lot of practice.
Thank you for the tip I needed
U do not have to glue the pad like that!! geez
With this carpet and the tape down installation method, can you get a really clean, flush transition to hard flooring like tile or polished concrete without using a threshold or any type of transition strip?
Yes. You would make you guys off the back. But it works well.
Where did u get ur vynil decking membrane from?
This product is from global deck-king.
@@mrfantum1 how much was it and what sizes do they sell them in?
@ManuelHernandez-br6dy they come in rolls up to 75 ft. They sell the material for about $3.50 to 4.00 a square foot Canadian.
@@mrfantum1 do you know if they sell these in the US?
@ManuelHernandez-br6dy I don't know for sure. Check the global deck-king website for dealers
They should still be pulling all that extra concrete away from screed
Is there not a need for a vapor barrier?
No.
What keeps that pad from soaking up all the moisture from the concrete?
We usually have drain tile under the concrete to keep the concrete dry. If you have high water table you would have to address that first.
What is the sealer?
Solvent based glue essentially. It keeps the seam from fraying
I have twice
Utility. You were struggling, my man
Only when you try to video it.
Good work.
Horrible job
Thanks
Why no mitres borders?
It's the way they wanted it
promo sm
Must've put in 100,000 yards in my life of that. Haven't done one in about 2 years now
Have you cut it all in 😂
I did not. But I realized my mistake while talking this video
I definitely remember, and I definitely do not miss it
Apparently not you all that much you with a utility knife and cutting into that plastic door trim !
The days of a hook knife are gone also
5 in 1
Oh yeah
Nah family was never that cheap lol 😂
I love the soothing music you have been putting in your shorts
Wonder how they get rid of the whole rebar on the floor problem 🤔
Look at the four guys discussing what they are gonna do for work after the boss buys this little screed
Lazy 😅
Works for luan staples too
Show us how you do them cuts… thats why we are here mann thanks!
Seen a guy use a kicker instead of that chipper
Not sure how well that would work
Use what u got 👍👍
Never seen that before
Ok Mr Fantum.... Please tell me the name of that cutter/chopper/slicer device.... Or link it.... Curious if it's in a diy budget.
MARSHALLTOWN Ultra-Lite Flooring Cutter 13", Cuts Vinyl Plank, Laminate, Engineered Hardwood, Siding, and More - Honing Stone Included, Made in The USA. a.co/d/eHpjAFS
Good idea
What's the tool called. Is it an attachment for an angle grinder?
This is a brushless grinder with a diamond grinding cup and a dust shroud.
Yeah good day doing stairs kills me back lol
20 ,000 sqft after
Your bead needs to be closer to the top of the base.been doing commercial floors since the 90's
so satisfying
Very!
That's the easy part of the job out of the way.
@@garrysorbie1948 ohk 😄